This image shows the front right amp board after the new capacitors are installed.
(Front amps have one less capacitor to change out)
Note: You don't need to put the capacitor wires through the board as long as
solder is still going through the board. Surface mounting the capacitors
is easier and works just the same. When removing the old capacitors leave the
wires running through the board. that way a good contact is maintained.
It may not be the prettiest soldering job but it works.
Use a soldering iron with a fine point and allow it to heat up fully.
No comments:
Post a Comment
Your comments, corrections or input is welcome!